Stalk Roll Puller

Stalk roll puller designed to pull roll completely off gear box. Heat treated jaws, zinc plated, with locking chain clamp included. Use with 1/2"or 3/4" drive impact. Chain lube recommended.

Use on John Deere 40 and 90 series corn heads to remove tapered and straight snapping rolls and knife rolls. Also 600 series straight flute cast rolls with rectangular hole below spiral as pictured below (see RP600 for puller to use on rolls with rectangular cavity between flutes). 

$249.95

Shop Now

Auger Spout Extension

Combine unloading auger spout extension. Adds 1-1/2 ft. of tube length and  up to 3 ft. additional throw.

Kit includes outer tube extension, plastic angled spout with rubber breakaway, flighting, outer bearing support, grain saver, hardware, instructions.

For John Deere 6620, 7720, 8820, 9400, 9410, 9500, 9510, 9600, 9610, 9450, 9550, 9650, 9650CTS, 9650STS, 9750STS, CTS, CTS II.

$779.00

Shop Now

Auger Trough Repair Kit

Grain tank auger trough repair kit. Covers full width of combine grain tank.

Includes stainless steel repair panels for front and rear troughs, hardware, instructions.

For John Deere 9560STS, 9650STS, 9750STS; 9570STS, 9660STS, 9670STS, 9760STS with 7-1/2" diameter standard rate cross augers.

$560.95

Shop Now

Tiger Shark Section

Tiger Shark sickle section, 3.5 teeth/in., chrome. Extra aggressive, excels in tough stem soybeans. Stays sharper longer. Made in USA.

For John Deere 600D, 600R, 600F, 600FD, 900D combine platforms.

Width - 4"
Length - 3-1/4"
Hole Spacing - 1"

$2.29

Shop Now